I have had the opposite problem on landing. Rolling out at about 40 knots when a sudden head on wind gust put me at flying speed. The Tomahawk immediately jumped up to about 20' above the runway. Had
I have just found a distributor of Epibond 420 A/B that will have 3 quart kits in stock at $277.59 + shipping. Those of you that have tried to purchase this stuff will understand why I am sharing thi
The distributor that will have 3 quarts in stock in September is: Krayden Industries Denver, CO 1-800-448-0406 I spoke with Edie to place my order. Vaughn Teegarden N914VA
Of all the things I've lost, I miss my mind the most! -- Original Message -- From: Graham Pocock To: europa-list@matronics.com Sent: Wednesday, August 30, 2006 11:38 AM Subject: Re: Europa-List: Epib
I am wondering if anyone has done the Flightcrafters conversion to conventional gear (taildragger), and if so, what is their opinion of it's worth? Also, how hard is it to do on a completed XS mono?
I couldn't even get insurance while I transported my kit, so I have decided to go the non-insured route. Even after you pay for insurance after years on end, when you go to file a claim, the chances
One other issue. The starboard end of the elevator torque tube needs to be raised abou 1/4" in order to make it level with the fuselage sides. I'm assuming that if I I bond the top on with it raised
I am presently scuff-sanding the mating surfaces prior to bonding the top on the fuselage. Would it be wise to lock down all the adjustments for the elevators and trim tab before doing that. All trav
Thanks to all for the hints. I will safety wire the mass balance arm turnbuckles. tighten all control adjustments, and tweak the already installed torque tube level before bonding on the top. I'm als
I was able to get a 1 quart kit from the people below. When I ordered mine in September, they had 3 quart kits left. It's now called Epibond 420. The distributor that 3 quarts in stock in September i
I think this is where the FAA would like to take us here on the left side of the pond. Thank God we still have the second amendment(unless of course the Democrats get their way). What??....... I didn
Hi Jeff, You seem to hang around with a bunch of car nuts. You would probably like my '88 Fiero with the 4.9 Cadillac V8. Vaughn T XSmono, Wiring and preparing for top installation -- Original Messag
Please note that if you are driving a bearing into a tight recieving area, a piece of pipe or a socket must be placed over it, so that you are only appling force to the outer race of the bearing. Oth
Hi Martin, I have purchased the Grand Rapids Technology dual screen Efis and EIS. Unfortunately, I have not wired it all up yet. I'm severly challanged when it comes to sparks. Their drawings and ins
Rob, I must say that I am somewhat offended. I spent 4 years in the US Navy, and even on the rare occasions when I was drunk, I did not spend money as foolishly as the US government. Please be more c