Delivery Failure Report
Your Re: U/C shims
document:
was not "Carl Reynaud AT RAY_RMC_NAUTECH@EO"
delivered
because: User "Carl Reynaud AT RAY_RMC_NAUTECH@EO" not
listed in public Name & Address Book
EOLEX-MS01/EO/Raytheon/US, EOLEX-MS01/EO/Raytheon/US,
EOLEX-MS01/EO/Raytheon/US
________________________
cc:
From: europa@avnet.co.uk AT smtp-ecn@eolex_ecn@EO-ccMail
Date: 06/23/97 06:45:26 PM
Subject: Re: U/C shims
Try one of the model shops in Wellington. You can usually pick
up small sheets of different thicknesses at good model shops
without having to pay through the nose.
Tony
------------------------
From: "Bampfylde John (NZ-WGTN-PIC)" <wlgjsba@eynz.co.nz>
Subject: U/C shims
Date: Mon, 23 Jun 1997 08:10:00 +1200
>
> Do most builders need to fit brass shims on the U/C swinging
arm? If so,
it
> looks like another little trip to the engineering supplies
shop for a
square
> inch of shim material costing $100+....
>
> John Bampfylde, #130
> _____________________________________________________________
_________
> The Europa List is supported by Aviators Network UK -
info@avnet.co.uk >
---------------End of Original Message-----------------
---------------------------------------------------
Tony Krzyzewski tonyk@kaon.co.nz
Managing Director Ph 64 9 358 9124
Kaon Technologies Fx 64 9 358 9127
Auckland
New Zealand
Networkers visit www.kaon.co.nz
Aviators visit www.kaon.co.nz/europa/272index.html
----------------------------------------------------
_______
The Europa List is supported by Aviators Network UK -
info@avnet.co.uk
by gatekeeper.ray.com
Date: Mon, 23 Jun 1997 12:11:48 +1200
From: Tony Krzyzewski <tonyk@kaon.co.nz>
Subject: Re: U/C shims
|