I have just deftly cut the servo tabs out of my stabilizers (a surgeon would
be envious) and am getting ready for the close outs. I seem to remember that
someone had mentioned that the hot setup was to lay in 3 plies of hinge
reinforcing material instead of 2 as noted in the build book. Is this indeed
true has there been a problem here? I might have caught this from some other
hinge issue. I don't necessarily want to get in the mode of adding extra
material and supports where not needed. Throughout 3 or so years of building
and adding this could "led sled-itis". Is there any history on this? Fill me
in.
Thanks
Steve Hagar
A143
Mesa, AZ
|