Thanks both for your ideas. The problem really is only with the front top. Top,
back and bottom edges fit nicely, the tabs need trimming but would end up in
place. If I start out using the top front as reference I would get gaps on all
other edges and the reinforced parts of the tabs would not fit in the recess
anymore. Perhaps the best thing is to finish it as-is and then fill the gap in
the front edge with flox.
--------
Jeroen
http://www.europaowners.org/main.php?g2_itemId=44165
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=373474#373474
|