>
> The manual calls for some less than typical drill bit sizes, e.g.
> 3.3mm. Is it somebody's maths is slightly suspect and they are
> trying to quote a metric equivalent for 1/8" or do I really need
> 3.3mm ?
>
> Clearly such bits are not available down the local DIY store.
> Anybody suggest a suitable supply in the UK ?
>
> Thanks,
>
> Dave Howard
> #309
>
The rivets used are metric and the drill sizes are quoted from the
manufacturer's data. However the number 30 drill should be close enough.
Note that a 4.8mm drill is used to make holes for AN3 bolts, not a 3/16"
drill. The AN3 bolts are slightly larger than 3/16". A number 12 drill
should be used here.
Regards
Andy Draper
-------------------------------------
Web Site at www.europa-aviation.co.uk
Fax No 44 1751 431706
-------------------------------------
|