| Subject: | Re: re-introduction & weight question |
|---|---|
| From: | Graham Singleton <100421.2123@compuserve.com> |
| Date: | Fri, 16 May 1997 20:01:48 |
>>Weighs 9.7 oz., it is quite hard, has about 3/4" radii and is all very matte finish. Maybe too little resin??<< Dunno, Chuck. The only calibration I know is the Burt Rutan one. 6 plies BID, 10"X16" should weigh 11 oz. or so. If there are white flecks in the layup, that's air. Too light on resin. If there are no white flecks it should be OK. Graham |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: re-introduction & weight question, ChuckPops |
|---|---|
| Next by Date: | Re: Door Security, Tony Krzyzewski |
| Previous by Thread: | Re: re-introduction & weight question, ChuckPops |
| Next by Thread: | RE: Trim Systems, et. als., Robert L . Nuckolls III |
| Indexes: | [Date] [Thread] [Top] [All Lists] |