> >> He actually micros the surface
> beforehand, lets it dry and then light sands the surface before laying up<<
>
> Don't think I'd do it that way.I expect it would bond OK but it would be
hard to
> sand accurately on a foam an micro surface. For good sanding you need a
> homogeneous surface and breaking through the micro to soft faom would be a
real
> pain.
They were my thoughts exactly! can you imagine what a mess you could make if
you did the whole wing that way!!!
Tony
---------------------------------------------------
Tony Krzyzewski tonyk@kaon.co.nz
Managing Director Ph 64 9 358 9124
Kaon Technologies Fx 64 9 358 9127
Auckland
New Zealand
Networkers visit www.kaon.co.nz
Aviators visit www.kaon.co.nz/europa/272index.html
----------------------------------------------------
|