I created the diagram by sticking graph paper onto the actual panel and then
drawing lines at the points where the panel curved away either up or down.
The intent was to create a plot that showed the flat useable surfaces.
Somebody else can do the plan and side view! Any voluteers :-)
Tony
------------------------
From: Gramin@aol.com
Subject: Panel drawing
Date: Sun, 8 Jun 1997 09:04:24 +1200
> Tks for the dxf Tony. It fits inside mine, which I think is accounted for
by
> yours showing the plywood outline, right ? You can get a bit more actual
> panel for bezels and labels outside that.
>
> Back to the drawing board though, we need some side and planview sections
too
> !
>
> Graham C.
>
---------------End of Original Message-----------------
---------------------------------------------------
Tony Krzyzewski tonyk@kaon.co.nz
Managing Director Ph 64 9 358 9124
Kaon Technologies Fx 64 9 358 9127
Auckland
New Zealand
Networkers visit www.kaon.co.nz
Aviators visit www.kaon.co.nz/europa/272index.html
----------------------------------------------------
|