Try one of the model shops in Wellington. You can usually pick up small
sheets of different thicknesses at good model shops without having to pay
through the nose.
Tony
------------------------
From: "Bampfylde John (NZ-WGTN-PIC)" <wlgjsba@eynz.co.nz>
Subject: U/C shims
Date: Mon, 23 Jun 1997 08:10:00 +1200
>
> Do most builders need to fit brass shims on the U/C swinging arm? If so,
it
> looks like another little trip to the engineering supplies shop for a
square
> inch of shim material costing $100+....
>
> John Bampfylde, #130
>
---------------End of Original Message-----------------
---------------------------------------------------
Tony Krzyzewski tonyk@kaon.co.nz
Managing Director Ph 64 9 358 9124
Kaon Technologies Fx 64 9 358 9127
Auckland
New Zealand
Networkers visit www.kaon.co.nz
Aviators visit www.kaon.co.nz/europa/272index.html
----------------------------------------------------
|