>About to cut out the 70mm square plywood pieces for the spar bush
>reinforcement, I suddenly realized I haven't the foggiest idea which ply
>piece to cut them from!
>I have 7 3mm plywood pieces left, labeled F06,2,3,4,6&7, with no hint as to
>where each of them is destined. I don't wish to cut up anything that I will
>need later. The fuselage manual's Annex A-3 (Fig. 1. 3mm Plywood /Cutting
>Plan) is no help, as there are no dimensions, and it seems to be obsolete as
>it presupposes 2 760 mm squares supplied, and I have instead a number of
>various sized rectangular pieces.
>
>How about it, Andy? Am I missing something? Is there a key to where these
>pieces are supposed to be used?
>
>Pops
>A-36
>
Your bits of plywood should be used as follows:-
F06 Rear bulkhead
Ply-2 Thigh support ribs (3 off)
Headrests (2off)
Rudder pedal floor (2 off)
Ply-3 Spar pin bush reinforcements (these are the ones you need
at the moment)
Ply-4 Elevator mass balance guide / limit stop
Ply-5 Fuel tank supports (2 off)
Fuel selector valve mount (1 off)
Spar pin latches (1 off)
Ply-6 Fin rear close out
Ply-7 Tunnel bulkhead behind main wheel
Regards
Roger Bull
____________
Address for Europa Aviation technical back-up is
enquiries@europa-aviation.co.uk
|