hello all,
just been reading TonyK's builders log and noticed
he cut some tufnel spacers, I assume for the rudder cables
around the engine mount.
I took Graham Singletons advice and sleeved the
rudder cables from the pedals to the pulley, put a strip of
2 layers of bid along it to hold it all in place except for
about 6 inches at each end, free to move as required. If
set up carefully, the sleeve extends just about level with
the u/c frame, adding extra protection against chaffing
here. Try A/C Spruce Nylaflow nylon tubing 3/16 od x 0.138
id.
chus, dave
kit67
(also known as davebuzz@aol.com)
|