[Peter said]
I'll add:
An old trick, and a good one. Before you shell out the big
bucks for
the jig, use your drill press table vise to hold a nut with the flat
straight up. Center punch the spot where you want the oblique hole to
start, now drill a very small pilot hole partway into the flat, going
straight in.
This gives you a good starting point for the final oblique hole
between
two flats--just reposition your nut in the vise and have at it.
------------------
I urge *extreme* caution to any members having at it with their nuts in
a vice.
Sounds dangerous (and painful) to me....
;-)
Andrew
|