Dear Epicures of Epoxy,
I'm ready to bond the hinges (yes, I'm using the three as per the
manual) to the flange, but I'm not quite sure about one thing. I don't
see how clamping the hinges to a straight edge has any effect towards
keeping the hinges in line once you've clecoed / riveted them into
place. I used the straight edge when drilling the holes, so I know
things are as in line as I can get them. Would a straight edge make any
difference after the fact? If so, should I support the weight of the
straight edge with foam blocks or something in order to keep its weight
---From pulling everything down?
Your help in this 'pivotal' matter is greatly appreciated,
Steve Genotte
|