A very neat solution for terminating 4 AWG wires with battery connectors was
in this month's Experimenter magazine. Normally these require professional
crimp equipment ($$$) or some good soldering techniques (see Bob Nuckoll's
web site for how to do this).
The technique shown in the tip was to simply use your Nicopress #2 squeezer
that you did your rudder cables with! Use the 3/32 hole and go squeeze, you
end up with a connector that is tightly bonded to the cable.
Tony
--
Tony S Krzyzewski Kaon Technologies Ltd
Managing Director PO Box 9830
Ph +64 9 520 4631 Epsom
Fx +64 9 520 3321 Auckland NZ
Reply to tonyk@kaon.co.nz
Networkers visit www.kaon.co.nz
Aviators visit www.kaon.co.nz/europa/
and www.kaon.co.nz/saanz/
-------
|