Re: U/C Mod

[Kenneth S. Whiteley <ken@kenwhit.demon.co.uk>]

In message <005c01be7fbb$58cb8f60$139ca4c2@bmaa.avnet.co.uk>, Dave
Simpson <Dave_Simpson@londonweb.net> writes
>
>Surely the problem is a bearing strength one, not a poor fit of the pin in
>the hole from manufacture.  If it's bearing strength, then an expanding pin
>will only provide a temporary solution.

I don't quite agree. My fittings have been a disappointing fit since new
(and haven't been flown yet). Secondly the wear will be much more rapid
if there is movement.
Ken Whiteley