Just as a point in passing the maximum weight of epoxy mix I put together
was 100 gms. And with regards to calculating ,if you weigh say 5 grams of
hardener into your pot which was already zero'd on the scale then it's no
big deal (subject to knowing your FIVE TIMES TABLE ) to add resin until the
total weighs 25 grams.?
So it follows that any number you start off with needs to finish up 5 times
greater. Presuming we are still on a four to one ratio.?
That way you only have to be accurate when adding the resin since if you go
over with the hardener the total you finish up with is .........!
Regards
Bob Harrison G-PTAG
-----Original Message-----
On Behalf Of Steve Hagar
Sent: 12 December 2000 05:49
Subject: RE: Digital scale and level
Andrew:
I have had much better luck with a mechanical Ohaus mechanical 700 series
triple beam balance as apposed to a digital scale. The balance is good for
slightly over 2 and a half kilograms total. You don't wind up chasing
numbers around also, some digital scales lag in updating the display. With
the triple beam you measure out your resin multiply by 27 and divide by 100
add that value to your resin number and move the weights to that number.
You then have a nice analog needle to watch as it approaches and centers on
its mark. It is more intuitive than chasing numbers and being mechanical it
at least offered me a good feeling that is working right and in a linear
fashion. This is something I don't have a good feel for when watching
numbers oscillate on a screen. These balances are pretty easy to come by.
They had them in science class when I was in high school, and when I was
in the Air Force all the pot heads heads in the barracks had them. Just
head to your local doper supply house and they should be able to fix you
right up. I got mine at ENCO in the US (tool supply house) for about $125.
I have found that the digital level was a very handy device to check the
washout on the flight control surfaces, also travel on the ailerons and
flaps etc. I expect it to be very handy when setting wing incidence. I have
already gotten my $100 worth out of it. At this point I am finishing my
last wing.
Steve Hagar
A143
Mesa AZ
> [Original Message]
> From: Andrew Sarangan <europaxs@usa.net>
> Date: 12/11/00 9:46:08 AM
> Subject: Digital scale and level
>
>
> I am buying a few tools in prepartion for my Europa project. I have a
couple
> of questions, and I hope someone can answer.
>
> Digital scale: what accuracy is required from a digital scale? I have seen
> ranges from 0.001g to 2g accuracy. Walmart sells a digital kitchen scale
for
> $20 with a 2g accuracy. Is this good enough?
>
> Digital level: What specs should I look for? Is this tool really neessary?
> What's wrong with a carpenters spirit level?
>
> Thanks!!
>
>
--- Steve Hagar
--- hagargs@earthlink.net
|