Jim.
I finished my inventory. It appears to be almost exactly the same as
Shaun Simpkins has sent to me with some minor differences...
Extra parts.
These were not located on any of my Bills of Material sheets, but as I
look at the builders manual, it appears that most of these items are
required. These discrepancies are a bit unnerving.
XTW12
FL1
FL2
FL3
FL7
XA2
XA4
EUR001
W36
Other questions?
F10 - What is a fuselage stern post?
I'm assuming (but not sure) the 122BMC, 122BPAB and 122BPAC were all
three in that bag with the Brake Kit.
The bag with the 638 Loctite contains a smaller bag with an FL9 in it.
There are 6 washers in it.
I'm assuming the Expancel is the stuff in the big box. Am I correct?
Hoses: One about 5.5in long, and one about 4.5in long. 7/8" ID
Missing:
TU1 1in OD x2 (No clue)
TU2 2024 T3 - .5" x .035 x 28"
OR4/7 Latch arm (But got an OR4/8 as did Shaun)
FL20/2 L.A. Flap push rod (But, got an FL20)
LG09/1 Retraction Arm Pivot (ground) (But, got an item labeled LG09)
1in hose 1in ID fuel del hose x5
1.25 in hose 1.25 ID hose x 4
F08 Rear fuselage hatch cover - What does it look like? If it is the
half moon thing then I have it.
TU4RM 4130 .75x.035in x 40
W54 - I may have this and not know it. I couldn't figure out what it
was.
TPA01 - Tail Plane Torque Tube. (What is it?)
Did we decide the CS17-1 was that very large pipe that was in the
fuselage?
The following items were in the small parts bag, rather then where I
expected them to be as listed on one of the Bills of Material. I don't
know if there are supposed to be duplicates.
AN960-416L Washerx2
AN970-3 Washerx6
AN3-14A Boltx1
AN3-10A Boltx2
Euro37 3316 Pre Assemble Nuts x6
I think that's about it. I'm quite surprised there are such
discrepancies. When will we all receive these things Jim? I understand
we all have about the same list.
Jeff
|