I just tried again and finally got to the pics. We just went through this
step yesterday. I just filled in the "trough" with some dry micro before
laying up the uni plies. At most, the micro is about 3/16" wide, and I made
no attempt to fully blend in the foam/glass transition. These cores were not
very good with regard to the trailing edges, having a very poor matchup. The
rest of the t.e. will get blended with filler at the paint stage to make it
look pretty. It turned out pretty well, tho. FINALLY, we see the end of the
layup tunnel!!!
Chris A159
Rob Waters <robw@iprolink.co.nz> wrote:
> Try again Tony. The pics were there when I looked. Unfortunately I don't
> know the answers.
>
> Rob
>
> Tony Krzyzewski wrote:
> >
> > I may as well be first to tell you - there are no images on that page.
> >
> > Tony
> >
> > -----Original Message-----
> > From: owner-europa@aztec.houxou.com
> > Subject: HLP - Ailerons again!
> >
> > Forwarded from the bounce bin. Message is from
> > "Keith Tallent" <ktallent@avnet.co.uk>
> >
> > *******************************************************
> >
> > It's me again...boy will I be glad to see the end of these big wet
layups!
> >
> > After turning over the first lay-up, removing the trailing edge support
> > block and peel ply, I have a couple of problems.
> >
> > For problem details, photos and questions, click on this link...
> > http://www.thehangar.co.uk/help.htm
> >
> > I would be grateful for any advice supplied.
> >
> > regards
> >
> > Keith Tallent
> > Kit No 221
> > XS Tri-Gear G-SAMY
> >
> >
|