Folks,
I need a bit of advice. I am preparing to fix the hinges on my trim tabs
and I just reread the recent thread about alodyning/anodising any aluminium
parts. Should I be doing something with my hinges before I bond them in? I
spoke to my inspector and he did not think it was necessary for the hinges,
but I would be grateful for your opinions.
As a follow-up question - I understand that you can do alodyning yourself,
but what do I need to get to do it and where can I get the stuff from? (I'm
in the UK, by the way).
Thanks
Rick Sivier
|