Hi Chris
Take a look at http://pma.obtero.net/jul-00.html . I cut off the ledge of
the cockpit module by mistake so I had to do mine a little differently. I
made the floor pieces first, covered with bid and put in the rivnuts. I
then attached it to the rudder pedal blocks and spot glued it in place and
then laid bid along the edges.
Cheers, Paul
----- Original Message -----
From: Dr. Christoph Both <christoph.both@acadiau.ca>
Subject: Rudder pedal floor: epoxy top AND bottom?
> Dear fellow builders:
>
> I require a quick answer to the following question:
>
> The manual specifies that only the rudder pedal bottom be glassed
> with 2 layers of bid. I heard that the top might need a full glassing
> job as well, not just the corners. Is this true. I appreciate an answer
> on this.
>
> Thanks!
>
> Christoph Both #223UK, Wolfville, Nova Scotia, Canada (anyone
> planning to visit Nova Sciota? Let me know: Thomas Scherer
> visited last summer on his flight to Oshkosh...)
>
>
|