Dick:
What's more important than getting the position of these items
spot to the nearest nano-millimeter is that they be relatively in
the same positionn on the left and right side. The push rod ends that actuate
the ailerons are adjustable to account for differences. So the thing to do
is to make a fixture with a hole in it to accept the aileron drive bolt.
This will set the location of the plate. Use a feature that you can pick
up on both the left and right aileron to act as a datum. Possibly the leading
edge of the aileron etc. Make sure that what you use as a datum is clear
of where you have to lay fiberglass on.
Steve Hagar
A 143
Mesa AZ
----- Original Message -----
From:
Subject: Installation of the
A2 Plate
I am ready to close the roots of the ailerons. Installation of
the A2 plate
and associated hardware to within one mm sounds tricky. Anyone
having any
hints or suggestions would be appreciated.
Thanks,
Wink
--- Steve Hagar
--- hagargs@earthlink.net
|