I'm getting ready to set up the bottom of the fuselage for work. I
would like a heads up from those of you who are passed this stage. I am
going to punch some holes in the fuselage to hang it from a holding fixture. Are
there some optimum places to put these so they won't interfere with work down
the road? More importantly are there any "keep out areas I should be aware
of?
My plan is to have 3 mounting points on each side. The two in the
front section of the fuselage on the same side are to be hooked to a
horizontal bar that has a pivot point at its midsection. This will be
hooked to my frame and allowed to rotate. The rear hole on both
sides will be hooked to a yoke type affair with a jackscrew then attached to my
frame which will have wheels on it. This way I can use the jackscrew
to level the aircraft. My driveway has a slight slope. I will need
to affix my wings here and I need an easy and accurate way to adjust the
incidence of the fuselage. Any other thoughts on this would be
much appreciated.
Thanks guys
Steve Hagar
A143
Mesa, AZ
N40SH
--- Steve Hagar
--- hagargs@earthlink.net
|