Tim & Dave, You will find that what you are tapping is a metal insert in the
structure, rather than simply fibreglass. Happy Xmas, David joyce
----- Original Message -----
From: Tim Ward <ward.t@xtra.co.nz>
Subject: Re: Door strut question
> Dave,
> No they don't supply a tap. I went out and brought one, however tapping
composite
> can be difficult,(not strong) so make sure you Redux the ball joint as
well.
> Watch for the ball joint coming right through as it can contact the door
moulding
> when closed and lift the door up to protrude above the fuselage at that
corner.
> Have a happy Xmas,
> Cheers,
> Tim
>
> DJA727@aol.com wrote:
>
> > Hi,
> >
> > I have installed my doors and am now attempting to install the door gas
> > struts. The instructions refer to drilling a 4.2mm hole and then a 5mm
tap to
> > accept the ball fitting. I usually answer my own question before
finishing
> > typing these notes, but does the kit provide a tap? I don't remember
seeing
> > one and I may have a little trouble finding a metric tap.
> >
> > Just wondering,
> >
> > Dave Anderson
> > A227
> > Motorglider
> > Gardnerville, Nevada
>
> --
> Timothy P Ward
> 12 Waiwetu Street,
> Fendalton,
> Christchurch,
> NEW ZEALAND
>
> Ph. 0064 03 3515166
> email ward.t@xtra.co.nz
> Mobile 025 2649325
>
>
|