All:
As a small and perhaps irrelevant service to other builders in their early
stages,
I have prepared a
diagram showing how all the hinge parts and pins are cut and shuffled to produce
all the control surface
hinges. If you have both tail and wing kits, you only need HW-1, the 9" extra
hinge pin, to do the job.
Which leaves HW-2, all 24" of it...
Anyway, if any builder would like to take a look at it, or if it is deemed
worthy
of the List Forum Support
Site, I would be glad to forward it.
Happy New Year
Shaun Simpkins
A207
|