RE: turnbuckles

[Rob Housman <robhousman@sbcglobal.net>]

This is definitely the best way to do it.  Be sure to order extra clips
because once you install the clip if you need to remove it you will likely
damage it.


Best regards,

Rob Housman
A070

-----Original Message-----
From: owner-europa@post.aviators.net
Subject: RE: turnbuckles

Use the MS series with the clips which will save you having to safety
wire them.

For each turnbuckle you need...

1 x MS21251-BS Barrel
1 x MS21255-3LS
1 x MS21255-3RS
2 x MS21256-1 clips

This gives you a turnbuckle with cable eyes.

A tip. When installing the ends, position the cable eyes so that the
groove to take the pin is pointing towards to the inspection hole. When
you ever come to adjust the turnbuckle you'll find it easier to reinsert
the pin if you can see the groove.

Tony