<3C9A044E.A7802083@ameritech.net>
>Hi Europaphiles
>
>I plan to use red, green and white LEDs under molded plastic lenses for
>position
>lights. There of course are lots of advantages, low power consumption, long
>lasting, bright, etc. I just need to make the lenses!
>
>Tom Friedland XS Mono N96V
Get some 2mm Plexiglas, make male moulds or plugs covered in billiard table
cloth. Heat the Plexi in an oven to about 150 deg C and pull over the plug(s)
There was an article in Sport Aviation about this a month or two ago.
Graham
|