Flap Position Indicator Problem ! Help required.

[Bob Harrison <ptag.dev@ukonline.co.uk>]

Hi! Instrumentation /Electrical experts.
I have a Mac Position Indicator attached to my flaps with red, green and
blue wires connected to   an LED Indicator separately circuited and  fused
---From the flap drive motor.
It has worked flawlessly for 18 months until last week when I needed to
access the rear of the panel to fix an auxillary socket for a hand held
Garmin 295. Obviously there is no relationship between the two but  since
then  the LED flap indicator stays at 0 deg. I checked out my connectors
where I had been working and found the blue LED wire broken.
Having now repaired the connection  it, the LED, stays on 0 deg irrespective
where the flaps are positioned.

I have taken some resistance readings near to the MAC deck as follows: -

With Flaps 30deg :-  blue wire to orange  4.86 ohms
(down)               blue wire to green  15.00 ohms
                           green Wire to orange 4.86 ohms

With Flaps 25deg :-  blue wire to orange 4.85  ohms
                           blue wire to green  613   ohms
                           green wire to orange 4.27 ohms

with Flaps 15deg :-  blue wire to orange  4.86 ohms
                     blue wire to green  1587  ohms
                         green wire to orange 3.29 ohms

With Flaps  7deg :-  blue wire to orange  4.84 ohms
                     blue wire to green   2891 ohms
                           green wire to orange 2018 ohms

with Flaps 0 deg:-   blue wire to orange  4.84 ohms
 (up)                    blue wire to green   4.80 ohms
                               green wire to orange 52.5 ohms

Can anyone deduce from the readings where I should look to reactivate the
LED to match the
actual flap position?

Your urgent consideration of this would be gratefully received since in
seven days time I'm joining a group on a France Fly round and would like to
get it fixed ASAP.

BTW the Trim LED alongside is working AOK.

Regards
Bob Harrison G-PTAG.