Hi! Richard.
You will actually need 13 deg. total range. See all the previous messages on
this subject.
Regards
Bob Harrison G-PTAG
----- Original Message -----
From: Richard <riddon@btinternet.com>
Subject: Tailplane incidence
> Having just fitted my trim tab servo motor, I am now trying to set up my
> tailplane incidence & trim tabs prior to opening up the slot in the
fuselage
> sides to allow the trim tab link rod adequate clearance. I find that the
> maximum 'up' elevation I can achieve is only around 11 degrees without
> cutting out more of the fuselage sides above the trim lines. I can
achieve
> around 6 degrees down which is more than necessary. Have I done something
> wrong?
>
> Any experiences to share?
>
> Richard Iddon (XS tri 533)
>
>
|