I am not pleased with the distance between the inside edge of my wing fairings
and the fuselage sides. Done per the instructions, I used mixing sticks to get
the 2mm gap, wich given some unevenness in the molded pieces and the curvature
of the fuselage, resulted in about a 3/16 gap. (One of those things where you
knew better, i.e make it flush, before you did it)
So, now I need to 'bend' in the flange or otherwise get a better fit. I've
tried a 'paint stripper' heat gun, but have not gone at it aggressively. (and
don't want to do it while the wings are mounted - too easy to damage the
fuselage.) Is this a viable option? Also, I'm concerned that it will end up
somewhat wavey. Anybody have any thoughts?
Thanks,
Cleve Lee
A198 Mono XS N396ST
Detroit
The ALL NEW CS2000 from CompuServe
Better! Faster! More Powerful!
250 FREE hours! Sign-on Now!
http://www.compuserve.com/trycsrv/cs2000/webmail/
|