Paul Hi!
>
>
> I'm sorry you've had a crap day but I'm not ready for a fight :-
I was only joking! Thanks for the sympathy though!
> ( Just thought I'd add a word of warning about the back end
> alignment. If the fuse bottom has the built in twist and it hasn't
> been corrected before setting up the tailplane torque tube then I
> believe it is best to live with a wonky fin than to have a wonky
> tailplane. As far as looks are concerned my wonky fin is only
> noticeable when I really look for it.
Good advice. I had the same problem as you with a twisted Fuselage. I
think... it has all turn out reasonably OK although I did under
supervision adjust errant angle of Fin by some reconstruction. It's the
same problem as hanging wallpaper. You are aware of the problem areas
or pattern misalignment. Nobody else notices!
Kind Regards
Gerry
Gerry Holland
+44 7808 402404
Europa XS 384
G-FIZY
Gerry Holland
gholland@gemini-resourcing.com
+44 7808 402404
Gemini Resourcing Limited
Hartham Park, Corsham, Wilts. SN13 0RP - UK
+44 1249 700630
+44 1249 700631 (Fax)
Website - http://www.gemini-resourcing.com
DISCLAIMER: This message may contain privileged and confidential
information.
If you think for any reason this message has been addressed in error
you must
not copy or disseminate it and we would ask you to notify us
immediately by
return email to info@gemini-resourcing.com. Internet emails are not
necessarily
secure. Gemini Resourcing Limited is registered in England with its
address at:
Hartham Park, Corsham, Wilts. SN13 0RP, England.
|