02/24/2003 03:09:14 PM,
Serialize complete at 02/24/2003 03:09:14 PM
I don't know how others have done this, but my locks are fitted to the
rear section of the door, and they work by contacting a stop (actually
just a circular clamp) on the push rod. I positioned the lock below the
push rod so that if it fails it will fail in the open position. It means
that a section of the door has to be cut out and reglassed in - it can be
done after the latch mechanism has been installed
Dave A061
"Paul Stewart" <paul-d.stewart@virgin.net>
Sent by: owner-europa-list-server@matronics.com
02/24/03 01:23 PM
Please respond to europa-list
To: <europa-list@matronics.com>
cc:
Subject: Europa-List: Door locks
<paul-d.stewart@virgin.net>
In the process of fitting the door latch mechanism. I'm thinking of
lockable
doors as per the factory accessory catalogue. Anyone who has fitted them,
I
was intending to bond the back plate into the door sill tomorrow, I don't
want to do this if fitting the locks will interfere.
Anyone got any advice
Paul Stewart #432
|