Murphy's law at work!!
I fitted the NACA vents in the side of the fuse, as recommended by the
factory. First time I operated them in situ, after completing the painting
of the fuse, the threaded pin snapped off one of them.
I have obtained a spare replacement & have been trying to work out how
replace the broken flap with a new one. The only way I can see is to grind
off the outer surround to the replacement, leaving just the flap and the
internal housing, then grind of the housing on the broken one. I can then
glue the replacement housing complete with flap to the existing outer
surround.
Anyone got any other solutions? Also what glue is best to glue the plastic?
Richard Iddon G-RIXS (back to working out where all the wires go)
|