Hi Rob,
I went with 1/2" rubber hose from the gascolator. Then split with a 'Y'
fitting purchased from McMasters. Then downstream from the pumps used AN
fittings to join them back into a single to the engine. I basically copied
what Kevin Klinefelter had done. Can send picture if you'd like.
craig ellison
A205
silverton. OR----- Original Message -----
From: "Rob Neils" <RobNeils@aimcomm.com>
Subject: Europa-List: fuel line connectors
>
> What's the recommended method for splitting the fuel line into two lines
to accommodate the fuel pumps then reuniting the lines again.
>
> I've put together brass fittings to bifurcate the line before the pumps
and rejoining the lines back into a single one after the pumps. The problem
is that the brass fittings weigh more than the pumps!
>
> Has anyone come up with a better way? Plastic? If plastic will the
connectors hold up to the gas and vibration?
>
>
> Rob Neils
>
> Trigear MG
> spokane, Washington
>
>
|