Paul
I have not done any painting but I would clamp 2 pieces of say 3" x 2"
projecting from bench to just encoompass the length of a flap. Then bolt the
flap between the wood pieces tightly enough to support the weight so that
you can have either the bottom side of the flap or top side of the flap
outward for spraying.
I have just thought that the hinge pieces are not at the extremities so you
could put a piece of rod through the hinge holes and those in the pieces of
wood and support the weight by holding the the flaps up with sticks from
floor into the ends of the flap closeouts.
JR (Bob) Gowing, Kit 327 in Oz
----- Original Message -----
From: "Paul McAllister" <paul.mcallister@qia.net>
Subject: Europa-List: Painting flaps
<paul.mcallister@qia.net>
>
> Hi all,
>
> I am looking for ideas on how to support the flaps for painting.
>
> Paul
>
>
|