OK.. I've measured the hinge placement on the door tangs about a hundred
times how and they are per the manual. When I put the doors on and open them
they're about 1/2 inch too high on the door frame tang. What has everyone else
done? Just move the hinges down? Is that structurally sound? So far I've found
chapters 33 and 34 woefully lacking. What's up with the crazy angle the straight
edge is on in fig 3 page 34-3?
http://idisk.mac.com/sdunsmuir/Public/DSCN2257.jpg
http://idisk.mac.com/sdunsmuir/Public/DSCN2258.jpg
Thanks,
SteveD.
|
