Paul
> This would be a question for the factory if it wasn't a weekend. The engine
> manual does not give much indication as to how the cable is fastened to the
> carburettor. I have tried clamping it under the flat washers, however this
> does not allow the cable to pivot as the carburettor arm rotates from open to
> closed. This causes the cable to bend a bit in the closed position. Am I
> missing something here ?
Yes. There is a special fitting (cant think of name!) with a hole. Nut and
Bolt of sorts.
I've woken up!
It's a Allen Bolt M5 X 12, Rotax part No. 241-846. It has a hole to allow
throttle cable through and is attached and clamped with Washer and Stiff
nut.
Should be in Kit somewhere.
Regards
Gerry
Gerry Holland
Europa 384
G-FIZY
+44 7808 402404
gnholland@onetel.com
|