Yup!
Paul, there is a small cylinder shaped device that is inserted in
the throttle lever. The cable is inserted into the cylinder unit and the
cable is fastened in position by way of a screw that "jams" the cable and
holds it there. It is the correct method.
Jim Nelson
N15JN
<paul.mcallister@qia.net> writes:
> <paul.mcallister@qia.net>
>
> Hi All,
>
> This would be a question for the factory if it wasn't a weekend.
> The engine manual does not give much indication as to how the cable
> is fastened to the carburetor. I have tried clamping it under the
> flat washers, however this does not allow the cable to pivot as the
> carburetor arm rotates from open to closed. This causes the cable
> to bend a bit in the closed position. Am I missing something here
> ?
>
> Paul
>
>
>
>
>
>
>
>
>
>
|