> [Original Message]
> From: Steve Hagar <hagargs@earthlink.net>
> To: Richard Holder <rholder@avnet.co.uk>
> Date: 7/6/03 9:04:44 AM
> Subject: Re: Europa-List: Throttle cable attachment, alternate style?
>
> Has anyone out there attached a standard vernier type throttle instead of
the Europa detailed throttle lever? Phoenix Composits out here put one in
a Europa they are building. The installation looks very sanitary. Though
there is no history on it yet.
>
> Steve Hagar
> A143 Mesa,Az
> (Panel and ineterior wiring, hope to hang the engine before the summer is
out. (Typical summer that is - the normal summer here lasts till October))
>
> > [Original Message]
> > From: Richard Holder <rholder@avnet.co.uk>
> > To: <europa-list@matronics.com>
> > Date: 7/6/03 1:38:00 AM
> > Subject: Re: Europa-List: Throttle cable attachment to the Carburetor
> >
> >
> > It is called a "solderless nipple".
> >
> > Richard
> > Richard F.W. Holder 01279 842804 (POTS)
> > Bell House, Bell Lane, 01279 842942 (fax)
> > Widford, Ware, Herts, 07860 367423 (mobile)
> > SG12 8SH email : rholder@avnet.co.uk
> > Europa Classic Tri-gear : G-OWWW, EGSG (Stapleford)
> > PA-28-181 : Piper Archer : G-JANA, EGSG (Stapleford)
> >
> >
> > >
> > > Yup!
> > > Paul, there is a small cylinder shaped device that is inserted
in
> > > the throttle lever. The cable is inserted into the cylinder unit and
the
> > > cable is fastened in position by way of a screw that "jams" the cable
and
> > > holds it there. It is the correct method.
> > >
> > >
> > > Jim Nelson
> > > N15JN
> > >
> > >
> > > <paul.mcallister@qia.net> writes:
> > >> <paul.mcallister@qia.net>
> > >>
> > >> Hi All,
> > >>
> > >> This would be a question for the factory if it wasn't a weekend.
> > >> The engine manual does not give much indication as to how the cable
> > >> is fastened to the carburetor. I have tried clamping it under the
> > >> flat washers, however this does not allow the cable to pivot as the
> > >> carburetor arm rotates from open to closed. This causes the cable
> > >> to bend a bit in the closed position. Am I missing something here
> > >> ?
> > >>
> > >> Paul
> > >>
> > >>
> > >>
> > >>
> > >>
> > >>
> > >>
> > >>
> > >>
> > >>
> > >
> > >
> > >
> > >
> > >
> >
> >
> >
> >
> >
>
>
>
> --- Steve Hagar
> --- hagargs@earthlink.net
>
--- Steve Hagar
--- hagargs@earthlink.net
|