----- Original Message -----
From: "Kevin Klinefelter" <kevann@gte.net>
Subject: RE: Europa-List: Ultimate Ventilators Question
| I too have installed these ventilators. A hole saw of 1 7/8" was used for
| the opening. I chose a position midway between the front and rear span of
| the windshield, just below the thick reinforced part of the fuse molding,
| and above the fuse moldings jogle. This puts the ventilator just above my
| knee and just clears the panel glareshield. After I cut the holes it was
| apparent that the skin is very thin and flexible there so I added two
layers
| of carbon bid to stiffen it up. The units were bonded in with redux from
the
| inside, a filet of redux around the 21/2" dia. edge.
Kevin et al,
I tried to 'see' these ultimatoes ventilatoes in the AS catalog
online, but was stiffed by need-to-sell pages. Can one get a gander at same?
Ferg
|