PS: Keep the drill cutter WELL lubricated and work your way up from a small
drill size using correct drilling speed - not too fast. Keep the lead ends
well clamped. If the drill bites into the lead the drill will probably stall
and it is almost impossible to remove without snapping the bit.
----- Original Message -----
From: "paul stewart" <paul-d.stewart@virgin.net>
Subject: Europa-List: aileron mass balance
<paul-d.stewart@virgin.net>
>
> Can anyone give a rough estimate of what proportion of the lead ends up
being removed to balance the ailerons?
>
> Regards
>
> Paul Stewart #432
>
>
|