Hi! Paul.
You should leave the pin holes and "rag" them full with a roller of smooth
prime. "Ragging" is to scrub the smooth prime into the pin holes with the
corner of the roller.
Regards
Bob Harrison G-PTAG
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com]On Behalf Of paul stewart
Subject: Europa-List: pin holes
<paul-d.stewart@virgin.net>
Having thought we were doing quite well with a 6HP vacuum to reveal pin
holes, the application of a compressed air blower has revealed yet more of
the little b*****s. Are we correct in continuing to fill and sand until the
last pin hole is banished or does primer take care of the odd one or two?
We are using superfil and intend to prime with smooth prime.
Regards
Paul Stewart #432
|