Good day All,
Since the search feature of the archive is down, I'm hoping somebody
remembers when they did this.
Just finished with installing the fuel selector valve in the cockpit module.
With it still upside down I went to drill the holes for the AN210-2A pulley
and the seatbelt anchor. I marked out the placement of the holes using the
measurements in the manual but they didn't look like the manual picture. The
pulley
hole is 1.25" from the rear vertical bulkhead and 1.5" down from the
horizontal surface. The seatbelt hole is .6" from each side of the lower corner.
This
puts the pulley hole below the seatbelt anchor hole (unlike the picture in the
manual) and the two holes wind up an inch from each other. The pulley is 2
1/4" in diameter. Wouldn't they interfere? What am I missing?
And a quickie, how many 4" inspection panels to the fuel connectors did
people put in....1 or 2?
Mike Duane A207
Redding, California
XS Trigear
|