Hi Al,
Did you make the drain wire (shield) one of your pins in the disconnect? The
drain needs to be connected so that it runs uninterupted to the stobe when all
is hooked up. Also, you will need to bond the drain wire on the power supply
end to the chasis of the strobe power supply to ground it. If it's not
grounded, it ain't draining and that might be the source of your interference.
You
can crimp a ring terminal on the drain wire at the power supply end and use one
of the power supply mounting screws to land the drain wire. A little
conductive grease under the ring terminal will help also.
Regards,
John Lawton
Dunlap, TN
A-245
|