Is that the same pipe as the factory supplies for the sight gauge? If so,
what about their brass fitting for attaching it to the tank outlet fitting,
plus an AN894?
Jeremy Davey
Europa Monowheel 537M G-EZZA
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Peter Austin
Subject: Europa-List: Re:I give up
> I've been searching for AN parts to serve the following need:
> Attach urethane 1/4"ID plastic fuel line to 3/8" aluminum fuel line
> fittings - (for the purpose of directing tank bottom drains to SAF-Air
water
> drains)
>
> The Aircraft Spruce catalog carries some AN parts but does not
seem
> to accomodate change-of-size fittings as needed above.
> If you have experience in this field, I would sure appreciate any info
such
> as where to research AN parts catalogs for the fittings.
> Much obliged in advance,
> Ferg Kyle
> Europa Classic mono
Ferg,
Not sure what you are trying to do, are you Teeing off from a 3/8 line or
connecting to an end of a 3/8 line? which ever way, you will require an
assortment of AN fittings.
For Teeing off:- 1 x AN825-6D, 2 x AN818-6D, 2 x An819-6D, 1 x AN910-2D, 1 x
AN912-1D and 1 x AN840-4D.
End of line:- 1 x AN818-6D, 1 x 819-6D, 1 x 816-6-2D,1 x AN910-1D and 1 x
AN840-4D.
The parts from Aircraft Spruce Cat, this was the only way I could figure out
to do it given the parts in the Catalog.
Regards
Peter #198.
|