Re: RE : Europa-List: roll trim tab and servo installation

[Rowland Carson <rowil@clara.net>]

>I hope you guys will be able to see the drawing!

Michael - was it supposed to look like this?

12V In--------+--------(1)-7805-(3)--+--------+----- 5Volt out
               !             (2)      !        !
               !              !       !        !
             1000uF           +-100nF-+       100uF
              (-)             !               (-)
               !              !                !
               !              !                !
ground--------+--------------+----------------+------ground

Yours wasn't really legible at my end, but after removing and inserting
some spaces I think I got it correct. I have shortened the line 
length slightly to prevent problems with mailers that wrap lines 
earlier than usual, and I am posting in plain ASCII text which should 
mean it will not suffer any distortion in transmission.

regards

Rowland
-- 

| Rowland Carson  PFA #16532   e-mail <rowil@clara.net>
| 650 hours building Europa #435 G-ROWI