Hello All,
I guess this is not a problem for those of us that are going to conventional
gear. I ordered my gear legs through Bob Berube at Flightcrafters and had it
"bullet drilled" internal to he legs. I attach my aluminum tubing to the top
center of the gear leg (which will be enclosed in fiberglass) then run a simple
short flexible hose from each bottom side of the gear leg to the wheel
cylinder.
Mike Duane A207
Redding, California
XS Conventional Gear
CM & rudder pedals with cables installed. Tailwheel complete. Wing pins and
tie bar installed. Working on baggage bay. Conventional gear assembled and soon
to be fitted.
But Sun-N-Fun comes soon!
|