Hi Bob
I would be very interested in a copy of this 8 pages of how to do it.
I'm presently trying to manufacture some lenses as well.
Could you send me a copy to my private e-mail ( hpreusser@tiscali.ch ).
Best regards
Hans-Peter
-----Ursprngliche Nachricht-----
Von: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] Im Auftrag von
R.C.Harrison
Gesendet: Dienstag, 6. April 2004 01:19
An: europa-list@matronics.com
Betreff: Re: Europa-List: Vacuum Forming Perspex.
<ptag.dev@ukonline.co.uk>
Hi! Duncan
This forum is the most amazing source of information .... within two
hours
of my message going out a kind chap at Boeing "patched" me 8 pages of
method
and temperature suggestions! Should you wish I can send it through?
The Air World one stands too high to get into my trailor safely and has
a
different base, the existing Gold Wing one needs to be only about 1/4
inch
higher to be futher away from the heat of the bulb.
I've had a female plug roughly cut in aluminium but have a lot of
"burring"
to do to get the final shape cut out then I was going to try the vacuum
thing. Just skip reading the 8 page detail above it could be possible to
do
with some combination of methods.
regards
Bob H G-PTAG
----- Original Message -----
From: "Ami McFadyean" <ami@mcfadyean.freeserve.co.uk>
Subject: Re: Europa-List: Vacuum Forming Perspex.
<ami@mcfadyean.freeserve.co.uk>
>
> >>Gold Wing .............. before they went belly up.<<
>
> I rather think they made a tactical withdrawal from the market, after
taking
> numerous paid-up orders that were never delivered.
>
> Presumably the Kunzleman (Airworld) fin covers are no good to you?
>
> I was going down a similar route to provide a more streamlined cover
over
a
> cylindrical fresnel lense. If you make a wooden plug of what you want,
it
> may be possible to persuade an aeromodeller canopy maker to do the
rest.
>
> I'll be interested to learn of your experience/progress with this.
>
> Rgds.,
> Duncan.
>
>
> ----- Original Message -----
> From: "R.C.Harrison" <ptag.dev@ukonline.co.uk>
> To: "Europa Matronic Circuit" <europa-list@matronics.com>
> Subject: Europa-List: Vacuum Forming Perspex.
>
>
> <ptag.dev@ukonline.co.uk>
> >
> > Hi! All you knowledgeable chaps.
> > I'm busy making a Vacuum mould for a obsolete fin strobe lens.
Anyone
have
> any guide lines on temperatures and draw angles, lubrication, sealants
> likely vacuum pressures or lack of it !Please. Alternatively anyone
know
> where Gold Wing got their lenses made before they went belly up.
> >
> > Regards
> > Bob Harrison G-PTAG Europa MKI/Jabiru 3300
> >
> >
>
>
==
==
==
==
|