> >I gotta ask - what's your technique for making the holes in the vee BELOW
> >the hinge holes bigger than the hinge holes????
>
> Jeremy - just goes to show you can't believe everything you read on
> this internet thingamajig!
>
> I was sure when I wrote it that I had done it, but on thinking
> clearly about the geometry, I can't imagine how it would have been
> achieved.
>
> Advantage Davey.
You take an old cleco and grind a cutting edge into the offset tip, then use it
as a boring tool (with the shank oiled) through the hinge hole.
Deuce ! ( only kidding, I used a standard drill too ...)
John Cliff
#0259
|