Paul,
I also have B&C fuseblock assys for Main Bus (10 fuses), Essential bus
(20 fuses) and Battery bus (6 fuses). All three fuseblocks are mounted
inside the shelf in front of the passenger, which is just large enough
to hold all the three. To make the fuses easily accessible I cut out a
door in the lower side of the shelf. The three fuseblocks are mounted
onto this door. The door is hinged to the firewall side of the panel. On
the passenger side it is closed with two suthco fasteners. Works great
for me!
Alfred
Alfred Buess
Laenggasse 81, CH-3052 Zollikofen, Switzerland
Tel.: +41 (0)31 911 63 32, Fax: +41 (0)31 911 56 32
E-Mail: ykibuess@bluewin.ch
Europa XS #097, Monowheel, Foam shortwing, Rotax 912S, Airmaster 332 CS
-----Ursprngliche Nachricht-----
Von: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] Im Auftrag von Steve
Hagar
Gesendet: Montag, 26. Juli 2004 17:29
An: europa-list@matronics.com
Betreff: RE: Europa-List: Europa electrics ( busbars)
Paul:
I have 3 busses I have built into the plane. Each bus consists of the
B&C fuseblock assy. The Main Bus, Essential bus. and battery bus. The
essiential bus is built on the vertical section of the shelf in front of
the passenger facing the passenger. I have built a bulged cover that
goes over this and is held in place with
Velcro. I cut a rectangular hole in the surface that is 90 degrees to
this surface in the side of the instrument panel. The main bus is
recessed in here on standoffs from the surface. A flat cover secured
with Velcro goes over this. The battery bus is under the baggage bay
area on one of the plywood uprights. I expect the battery to go under
the right compartment.
Steve Hagar
A143 Mesa, AZ
> [Original Message]
> From: <PPalmer007@aol.com>
> To: <europa-list@matronics.com>
> Date: 7/26/04 4:46:53 AM
> Subject: Europa-List: Europa electrics ( busbars)
>
>
> I am trying to determine the best place to position the busbars in my
friend
> danny's europa three are required. One earth busbar, one avionics
> busbar,
> and the main busbar. I dont want to re-invent the wheel so can anyone
> out
there
> help me???
> Many thanks Paul
>
>
==
direct advertising on the Matronics Forums.
==
==
==
|