Hi Richard.
I have the locking pin and the maintenance manual, both of which came with
the engine. If you have the manual, there is a picture on page 05-50-00, page 3
which shows where you put the pin in.
I came across it as I'm approaching 25 engine hours and was looking to see
what needs to be done at the 25 hour check. From the manual - just about
everything! Including checking backlash and friction torque, which needs you to
lock the engine using the pin.
Regards, Roddy Kesterton
In a message dated 07/09/2004 17:07:08 GMT Standard Time,
rholder@avnet.co.uk writes:
Does anyone have a manual which gives details ? In have the "Rotax
Maintenance" manual but that only covers routine maintenance like oil
changes. Is there a workshop manual which would give a breakdown of how the
flywheel and sprag clutch interact ?
I am sure there isn't a Haynes manual for it :-)
The manual I have talks of "the crankshaft locking screw (part no 240 880)
which is part of the standard tool kit supplied with each engine". Does
anyone HAVE one of these. I don't remember seeing it !
|